FRITSCH PULVERISETTE 19 - Manual (Page 15)

2.6 Protective equipment
n Protective equipment is to be used as intended and may not be disa-
bled or removed.
n All protective equipment is to be regularly checked for integrity and
proper functioning.
n The Universal Cutting Mill is equipped with a safety lock (11) which
also protects the operator. This locks the front closing lid (6) during
operation.
n The safety switches (11, 15) prevent operation of the Universal Cut-
ting Mill, if the cutting chamber is not closed or a collecting vessel (8)
has not been inserted.
n Do not operate the device without a funnel (1 or 22)!
Funnels (1, 22) are mechanical safety devices that enable hazard-
free filling.
n When changing the funnels (1, 22), disconnect the device from the
mains and install the new funnel (1, 22) immediately! (Ä Chapter 4.6
‘Selecting and converting the funnels’ on page 21)
n Motor safety switch (Ä Chapter 6.4 ‘Overload of the cutting mill’
on page 37)
2.6.1 Opening the cutting mill without mains connection
DANGER!
The lock (11) must only be released manually when the
closing lid (6) is closed.
The latch clamp (13) of the door must be locked!
1. Insert the supplied triangular key into the bore hole under the
safety lock (11) and turn it clockwise.
2. The closing lid (6) can be opened after opening the latch clamp
(13).
Safety information and use
- 15 -