FRITSCH PULVERISETTE 2 - Manual (Page 23)

n Rotation to the right = clockwise rotation
n Rotation to the left = anticlockwise rotation
An arrow on the mortar indicates the direction of rotation of the mill.
Rotate the mortar in the direction of the arrow to open the bayonet.
6.3.2 Installing/removing the pestle
The pestle is held in place with a catch holder and can be easily removed
without tools.
Pull the pestle in the direction of its axis to release it from the catch
holder. For this purpose, it is recommended to press fingers (thumbs)
against the lid (see picture).
Inserting the pestle shaft into the bearing locks the pestle into its
working position again. When inserting the pestle shaft, make sure that
one of the milled spanner flats (b) on the pestle is located next to the
drive screw (a).
6.3.3 Mounting the scraper
n The scraper included in the scope of delivery has to be screwed to
the guide rod before grinding for the first time.
n Place the scraper onto the guide rod, as shown in the picture, and
screw it lightly to the rod with the screw in the right hole.
n To set the scraper, refer to Ä Chapter 6.6.1 ‘Setting the scraper’
on page 27.
Note
Before installing the pestle, the pestle
shaft must be cleaned.
Using the device
- 23 -