Hangar 9 Pulse XT 40 ARF - Manual (Page 10)

10
 .  .Step 9
Slide.one.of.the.longer.pushrod.wires.into.the.wing..
Attach.the.servo.extension.to.the.“Z”.bend.of.the..
pushrod.wire.
 .  .Step 10
Pull.the.servo.lead.through.the.wing.using.the.pushrod.
wire..The.lead.will.exit.the.hole.on.the.top.of.the.wing..
Use.a.piece.of.tape.to.keep.the.extension.from.falling.back.
into.the.wing.
 .  .Step 11
Place.the.servo.into.the.opening.with.the.servo.output.
towards.the.trailing.edge.of.the.wing..Use.a.felt-tipped.pen.
to.mark.the.locations.for.the.four.servo.mounting.screws.
 .  .Step 12
Remove.the.servo.and.drill.the.locations.for.the.servo.
mounting.screws.using.a.1/16".(1.5mm).drill.bit...
Apply.a.couple.drops.of.thin.CA.to.each.hole.to.harden.
the.wood,.which.will.help.in.preventing.the.screws.from.
damaging.the.wood.
Section 1: Aileron Installation