Hangar 9 Pulse XT 40 ARF User Manual

Page 14

Advertising
background image

14

.Step 6

Drill.a.1/16".(1.5mm).hole.in.the.center.of.each.hinge.slot.

in.both.the.elevators.and.stabilizer..Prepare.six.CA.hinges.

by.placing.a.T-pin.in.the.center.of.each.hinge..Slide.the.

hinges.into.the.elevators.until.the.T-pins.are.resting.on.the.

leading.edge.of.the.elevator.

.Step 7

Slide.the.elevators.onto.the.stabilizer..Remove.the.T-pins.

and.use.thin.CA.to.glue.the.hinges..Allow.the.CA.to.fully.

cure.before.testing.and.breaking.in.the.hinges.using.the.

same.technique.as.the.aileron.hinges.

.Step 8

Since.the.holes.are.pre-drilled.in.the.elevator,.go..

ahead.and.install.the.control.horn.using.three..

2mm.x.12mm.screws.

Section 2: Hinging the Stabilizer

Advertising