Hangar 9 Pulse XT 40 ARF - Manual (Page 9)

9
 .  .Step 5
Position.the.aileron.so.it.can.move.freely.and.not..
bind.at.the.wing.tip.or.wing.root..Deflect.the.aileron.
without.changing.the.hinge.gap,.and.apply.thin.CA.to..
each.of.the.four.hinges..Apply.CA.to.both.the.top.and.
bottom.of.the.hinges.
Note:.Do.not.use.CA.accelerator.
on.the.hinges;.the.CA.must.be.
allowed.to.soak.into.the.hinge.
 .  .Step 6
Once.the.CA.has.fully.cured,.gently.pull.on.the.aileron.to.
make.sure.the.hinges.are.secure..Avoid.too.much.pressure.
which.could.cause.damage.to.the.wing.and.aileron.
 .  .Step 7
Flex.the.aileron.up.and.down.a.number.of.times.to.break.
in.the.hinges.
 .  .Step 8
Prepare.an.aileron.servo.by.installing.the.grommets.
and.brass.eyelets.provided.with.the.servo..Secure.
a.6".(152mm).servo.extension.to.the.servo.using.a.
commercially.available.connector.or.with.string.or.
unwaxed.dental.floss.
Section 1: Aileron Installation