Hangar 9 Pulse XT 40 ARF - Manual (Page 4)

4
Required Items for Electric Installation
•.Female.Deans.connector.w/wire. •.Male.Deans.connector.(3)
•.Soldering.iron. •.Solder
•.Phoenix-60.Speed.Control.(CSEPHX60). •.Electric.Propeller,13.x.6.5E.(APC13065E)
•.Heat.shrink.tubing:.1/4".(6mm)
•.4200mAh.2S2P.7.4V.Li-Po,.13GA.(THP42002S2PPL).(2)
Field Equipment Required
•.Propeller. •.Fuel
•.Long.Reach.Glow.Plug.Wrench.(HAN2510). •.Metered.Glow.Driver.w/Ni-Cd.&.Charger.(HAN7101)
•.2-Cycle.Sport.Plug.(HAN3001). •.2-Cycle.Super.Plug.(HAN3006)
•.4-Cycle.Super.Plug.(HAN3011). •.Manual.Fuel.Pump.(HAN118)
Optional Field Equipment
•.Fieldmate™.Pre-built.Flight.Box.(HAN117). •.Cleaner.&.towels
•.Blue.Block.After.Run.Oil.(EVOX1000). •.Power.Panel.(HAN106)
•.12V.7Ah.Sealed.Battery.(HAN102). •.PowerPro™.12V.Starter.(HAN161)
Required Tools and Adhesives
Tools
•.Adustable.wrench. •.Drill
•.Drill.bit:.1/16".(1.5mm),.5/64".(2mm),.9/64".(3.5mm),.5/32".(4mm)
•.Hobby.knife.
•.Masking.tape
•.Phillips.screwdriver.(large). •.Phillips.screwdriver.(small)
•.Ruler. •.Sandpaper
•.Square. •.Straight.edge
Adhesives
•.6-minute.epoxy. •.30-minute.epoxy
•.Thin.CA.(cyanoacrylate).glue. •.CA.remover/debonder
•.Pacer.Z-42.Threadlock
Other Required Items
•.Epoxy.brushes. •.Felt-tipped.pen.or.pencil
•.Mixing.sticks.for.epoxy. •.Paper.towels
•.Petroleum.jelly. •.Rubbing.alcohol
•.Sandpaper. •.String
•.T-pins