Hangar 9 Pulse XT 40 ARF - Manual (Page 23)

23
Required Parts
•.Fuselage. •.Rudder.assembly
•.Stabilizer.assembly. •.4-40.locknut.(2)
•.#4.washer
Required Tools and Adhesives
•.Adjustable.wrench
 .Step 1
Carefully.slide.the.threaded.rods.from.the.rudder.
assembly.into.the.stabilizer.assembly.
 .Step 2
Slide.the.tail.assembly.into.position.on.the.fuselage.
 .Step 3
Secure.the.tail.assembly.to.the.fuselage.using.two.4-40.
locknuts.and.two.#4.washers.
Note:.Do.not.over-tighten.the.
nuts.and.crush.the.fuselage.
 .  .Step 4
Connect.the.rudder.clevis.to.the.rudder.control.horn..With.
the.radio.system.on,.check.that.the.rudder.is.centered..If.
not,.either.thread.the.clevis.on.or.off.the.pushrod.until.the.
rudder.is.centered.
Section 6A: Tail Installation