Hangar 9 Pulse XT 40 ARF - Manual (Page 31)

31
 .Step 10
Locate.the.fuel.tank..Hold.the.tank.up.to.a.strong.light.to.
determine.which.direction.the.vent.line.is.facing..This.will.
be.the.top.of.the.tank..The.red.tube.is.attached.to.the.vent.
line.of.the.tank..Place.the.tank.inside.the.fuselage.with.the.
vent.towards.the.top.of.the.fuselage.
 .Step 11
Place.the.thick.piece.of.foam.into.the.fuselage.to.hold.the.
tank.in.position
Note:.Remember.the.plane.is.upside.
down.right.now,.so.the.vent.will.be.
facing.down.during.installation.
 .Step 12
Place.the.fuselage.hatch.into.position.and.secure.it.using.
the.4-40.x.1/2".socket.head.screw.
 .Step 13
Trim.the.cowling.as.necessary.to.fit.over.the.motor..The.
cowl.is.mounted.using.four.#2.x.1/2".sheet.metal.screws..
Install.the.propeller.and.spinner.using.the.instructions.
included.with.your.particular.motor.
Section 7B: Two-Stroke Engine Installation