Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 25)

HI 3010 Filler/Dispenser/IBC 12
User Guide
• Current Fill/Dispense
• Current Cycle
• Totals
• Setup Data
Press the Print button, the following screen appears:
FIG. 3-2 FILLER/PRINT SCREEN DEFAULT
Note that the cursor is in front of the Print Current Fill menu.
That is the default setting. The print button will only print
the menu with a cursor in front of it. To move to another
menu press the up or down arrow until the cursor is in front
of the menu you want to print. (See Fig. 3-3)
Up/Down - Left/Right Buttons
FIG. 3-3 DIRECTIONAL BUTTONS
The Up/Down arrow buttons move the cursor vertically
allowing the user to scroll through each item of a menu. The
Left/Right arrow buttons move the cursor horizontally left
and right. The Left arrow button has an added backspace
function. For example if there are Alpha/Numeric characters
that appear in the display, as you press the left button it
erases the characters. The Right arrow button moves the cur-
sor to the right in the display and does not erase a alphanu-
meric entry. The Left/Right arrow buttons also move the
cursor through a pick list. (See Fig. 3-3)
Enter Button
The Enter button enters the Alpha/Numeric value entered for
a menu item in the display. The Enter button also enters the
selections from a pick list. (See Fig. 3-4)
FIG. 3-4 LIST SELECTION/ENTER BUTTON
For example, when selecting units from a pick list, use the
left and right arrows to move the cursor in front of the unit
you want and press the Enter button. In the Standby Menu,
the Enter button toggles between Gross Weight and Net
Weight.
Exit Button
The Exit button disregards the current value entry, restores
the previous value and moves the cursor to the last menu.
Clear Button
The Clear button clears the total Alpha/Numeric Entry and
repositions the cursor for the first entry.
Ingr./1 Button
Enables you to change the pre programmed ingredient (1-12)
while in the Standby Mode. Also enters the integer 1 in the
display.
2/ABC Button
Enters the integer 2 in the display. Also enters the characters
A, B, C. Pushing the button once enters the integer 2.
NOTE: For numeric entries only: Push the button and
the number on the button is entered.
NOTE: For Alphanumeric entries only: Pushing the but-
ton once, the first letter on the button is entered in
uppercase, A, D, G, and so on. Push the button a
second time, the second letter is entered in upper-
case, B, E, H, K and so on. Push the button a
third time, the third letter is entered in uppercase,
C, F, I, L, and so on. Push the button a fourth
time, the fourth letter is entered in uppercase, S,
Z. Push the button a fifth time the first letter is
entered in lowercase, a, d, g, and so on. After you
go through the lowercase letters, you can push
the button again for the number. You need to push
the buttons rapidly. If you delay too long the
instrument will accept the alphanumeric charac-
ter and move the cursor to the left preparing for
the next alphanumeric entry. This is true for all
the Alphanumeric buttons. If this occurs use the
Pr int cur r ent Fil l
Pr int cur r ent cycl e
Tot al s
Set up Dat a
>