Kofax Ascen 7.0 Release Script - Manual (Page 20)

Ascent® 7.0 Release Script for XML Release Notes
16 Kofax, Inc.
Figure 2. Restart Windows Prompt (Click Yes)
6 The installation program will install the .NET Framework. When the .NET Framework is
installed, the message similar to the following will display:
Figure 3. Installation of .NET Framework Complete
a Click OK to close the message box.
b If the following prompt displays after the .NET Framework is installed, click No.
Warning If you are prompted to restart your computer immediately after the .NET
Framework is installed, do not restart your computer. If you do, your installation will
be incomplete and you will have to re-install the release script.
Figure 4. Restart Windows Prompt (Click No)
7 When the installation is complete, a message will display that indicates the release script
was successfully installed. If you are prompted to restart your computer after the release
script is successfully installed, choose to restart your computer.
8
Repeat this procedure on all Administration and Release workstations that will use the
Ascent 7.0 Release Script for XML.
Upgrading the Release Script
If you are currently using version 5.0 of the XML release script, you can upgrade to the Ascent 7.0
Release Script for XML, if desired. All release setup settings will be retained.
Important Note About Upgrade
To upgrade to the Ascent 7.0 Release Script for XML you must have Windows administrator
privileges. If you do not have administrator privileges and upgrade this release script, you may
receive error messages and several of the files may not upgrade correctly.
Before you upgrade to the Ascent 7.0 Release Script for XML, refer to System Requirements on
page 2 for information about installation requirements.