A&D Weighing HC-3Ki - Manual (Page 11)

9
3. BASIC OPERATIONS
3-1. Basic Operations
Turn The Power ON and OFF
1. Press the ON/OFF key to turn the
power ON.
All the display symbols will turn on. After
a few seconds, the display turns off once.
Then, the scale will automatically take
zero (power-on zero) and the display
shows zero.
2. Press the
ON/OFF key again, and the
power will be switched OFF.
‰
Auto-power off function
It is possible to have the power
automatically switched OFF. If zero is
displayed for approximately 5 minutes.
See “9-2. Functions” and set the
F-Function f-04-05 at “1” to enable the
function.
ZERO
‰ The ZERO key will bring the weight display back to zero.
1. Remove everything from the weighing pan and press the ZERO key. Then the
weight display shows “-------” and waits for the weighing data to become stable.
2. The scale will zero and the ZERO indicator will
come ON to indicate that the scale is ready to start
weighing or counting.
‰
There is automatic re-zeroing function called “Zero
Tracking”. The scale initially comes with this
function enabled to take care of normal drifts from
zero caused by changes in temperature, humidity,
air pressure etc. (F-Function f-04-01).
ON
OFF
888.8.8.88 0
COUNT
WEIGHT UNIT WEIGHT
TOTAL
M+
SAMPLE
TOO LIGHT
STABLE
TARE
ENTERED
ZERO
HI LO OK
ACAI
888 0.000 8
8
0.00000
888 0.000
WEIGHT
STABLE
TARE
ENTERED
ZERO
8 88.8.8.8.8.8
COUNT
WEIGHT UNIT WEIGHT
TOTAL
M+
SAMPLE
TOO LIGHT
STABLE
TARE
ENTERED
ZERO
HI LO OK
ACAI
8 88.8.8.8.8 8
8
8.8.8.8.8.8.