Alo 0 ut 0 00 – A&D Weighing HC-3Ki User Manual
Page 18
16
3-4. Unit Weight By KEYBOARD
1. The three
UNIT WEIGHT BY
LED’s should be blinking at this
point, if not, press the
RESET
key. to clear any unit weight. If you
are going to use a tare container, place it on the weighing pan and
press the
TARE
key. Be sure to set the weight display is “0”.
2. Press the
KEYBOARD
key.
The unut weight display and the
ENTER
key LED will blink.
3. Use the
0
Æ
9
and
.
10-key pad
to display the unit weight.
If you hit the wrong key, press
the C key to clear and start again.
(Example of a unit weight 32g)
4. Press the
ENTER
key.
The unit weight 32g will have been
entered.
If the unit weight entered is too light, “lo ut”
(low unit weight) will be displayed, and you
will be returned to step 3.
5. You may now begin counting operations for
pieces of the same weight.
KEY-
BOARD
888.8.8.810
COUNT
WEIGHT UNIT WEIGHT
888
0.000
8
8
add00
0
0
00
888.8.8.810
COUNT
WEIGHT
U
888
0.000
8
8
add0
32
0
00
ENTER
888.8.8.81
0
COUNT
WEIGHT UNIT WEIGHT
888
0.000
8
8
32.0000
0
00
888.8.8.810
COUNT
WEIGHT UNIT WEIGHT
888
0.000
8
8
a
lo
0
ut
0
00
Ñ
beep, beep, …Т