AltiGen MAXCS 7.0 Update 1 FXS Configuration with AudioCodes User Manual
Page 9
Configuring Analog Extensions with AudioCodes Gateways
Page 9 of 25
5.
Select VoIP > Media > Analog Settings. Configure the settings as follows:
Note: The AudioCodes device requires a reboot after you change either of these settings. You can reboot once
all configuration is complete, during the last step on page 17.
6.
Select VoIP > Control Network > Proxy Sets Table. Configure Proxy Set ID 0 as follows:
Figure 12: Configure the proxy IP address and transport type
•
Set Proxy Address 1 to 10.40.1.43:10060 (The
MaxCS public IP address and port). Set its
Transport Type to UDP.
•
Set Enable Proxy Keep Alive to Disable.
•
Set Min. Hook-Flash Detection Period [msec] to 300.
•
Set Max. Hook-Flash Detection Period [msec] to 800.
Figure 11: Configure the minimum and maximum detection periods