AXEON R2-Series - Manual (Page 7)

R2-Series User’s Manual
MKTF - 212
Locate the 1” or 3/4” connection (D
the concentrate line to an open drain in a free and unrestricted manner (no backpressure).
that an air-break be used on the concentrate line to prevent siphoning of water from the pressure vessels
when the system is in standby.
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
ELECTRICAL
The R2-Series systems pump and
Each R2-Series system is equipped with a 5 foot electrical cord
Ensure that the electrical circuit supplying the system is compatible with the re
R2 model you are installing.
NOTE: IT’S RECOMMENDED
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING POWER
SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
R2-Series systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
install it at this time.
PRE-FILTRATION
R2-Series systems are supplied with a
when a 10-15 psi differential exists between the pre
Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED
PUMP
The pump used on the R2-Series systems is a
Follow these guidelines to ensure proper operation of the pump:

The pump must NEVER
the pump.

ALWAYS feed the pump with filtered water. The pump is susceptible to damage from sediment
and debris.
7
Series User’s Manual
1” or 3/4” connection (Depending on the unit) labeled concentrate and
to an open drain in a free and unrestricted manner (no backpressure).
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
pump and motor are available in 220/460 Volt, 50/60 Hertz
system is equipped with a 5 foot electrical cord.
nsure that the electrical circuit supplying the system is compatible with the requirements of the specific
ED THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING POWER
PROTECTIVE EARTH GROUND.
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
systems are supplied with a 5 micron sediment filter. Change the cartridge
ists between the pre-filter. Ask your local dealer or distributor about Pre
NOTE: THE SYSTEM MUST BE OPERATED IN ACCORDANCE TO FEED WATER SPECIFICATIONS.
Series systems is a multi-stage centrifugal stainless steel
Follow these guidelines to ensure proper operation of the pump:
be run dry. Operating the pump without sufficient feed water will damage
feed the pump with filtered water. The pump is susceptible to damage from sediment
11/13/12
and attach to a drain. Run
to an open drain in a free and unrestricted manner (no backpressure). It is advised
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
50/60 Hertz, 1 Phase/3 Phase.
uirements of the specific
THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING POWER
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full. Liquid
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
. Change the cartridge once a month or
r or distributor about Pre-
IN ACCORDANCE TO FEED WATER SPECIFICATIONS.
steel type.
be run dry. Operating the pump without sufficient feed water will damage
feed the pump with filtered water. The pump is susceptible to damage from sediment