Switching off the engine, Parking brake, G brake applied – BMW 2012 3 Series M3 Сoupe User Manual

Page 64

Advertising
background image

63

Driving

Controls

Switching off the engine

Always take the remote control with you
when you leave the vehicle.

When parking, apply the parking brake force-
fully; otherwise, the vehicle could begin to roll.

<

Manual transmission

1.

With the car at a standstill, press the Start/
Stop button.

2.

Shift into first gear or reverse.

3.

Forcefully apply the parking brake.

4.

Removing the remote control from the igni-
tion lock, refer to page

61

.

Automatic transmission

1.

With the car at a standstill, move the selec-
tor lever to position P.

2.

Press the Start/Stop button.

3.

Forcefully apply the parking brake.

4.

Removing the remote control from the igni-
tion lock, refer to page

61

.

Sport automatic transmission with
double clutch

1.

With the car at a standstill, press the Start/
Stop button.
If the transmission is shifted into N when the
engine is switched off, you will be notified
visually and acoustically of this fact.

2.

Forcefully apply the parking brake.

3.

Remove remote control from the ignition
lock, refer to page

61

. The transmission is

automatically shifted into transmission
position P.

Parking brake

The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked; it
brakes the rear wheels.

Indicator lamp

The indicator lamp is lit, and when you
drive off an acoustic signal sounds in
addition. The parking brake is still

applied.

Indicator lamp for Canadian models.

Applying

The lever locks in position automatically.

Releasing

Pull slightly upwards, press the button and
lower the lever.

In exceptional cases, if the parking brake
has to be used to slow or stop the car, do

not pull the lever up too hard. In doing so, con-
tinuously press the button of the parking brake
lever.
Otherwise, excessive force on the parking
brake can lock up the rear wheels and cause the
rear of the car to swerve.

<

To prevent corrosion and one-sided brak-
ing action, occasionally apply the parking

brake lightly when the vehicle is slowly coming
to a stop if the traffic conditions are suitable.
The brake lamps do not light up when the park-
ing brake is applied.

<

Online Edition for Part no. 01 40 2 609 333 - © 08/11 BMW AG

Advertising