CAMCORP Cartridge Collector - Manual (Page 33)

BULLETIN NO. A-27
Page 4
Magnehelic ® Gage
EXPLODED VIEW
Series 2000
Ordering Instructions:
When corresponding with the factory regarding Magnehelic ® gage problems, refer to the
call-out numbers in this view. Be sure to include model number, pressure range, and any
special options. Field repair is not recommended; contact the factory for repair service
information.
©Copyright 1993 Dwyer Instruments, Inc. Printed in U.S.A. 6/93 12-440212-00
1. Case
2. Cover with zero adjust assy.
3. "O" ring seal
4. Bezel
5. Diaphragm sealing plate
6. Retaining ring
70. Range Spring assembly
a. Clamp set screw
b. Clamp
c. Mounting screws (2 req'd)
d. Clamping shoe (2 req'd)
e. Clamp plate screw
f. Spacer (2 req'd)
g. Clamp plate
14. Range Spring with magnet
150. Wishbone Assembly -consists of:
a. Front jewel
b. Locking nut
c. Wishbone
d. Pointer
e. Mounting screws (2 req'd)
f. Helix assembly (not shown)
g. Pivots (2 req'd) (not shown)
h. Rear jewel (not shown)
230. Zero adjust assembly-consists of:
a. Foot screws with washers (2 req'd)
b. Adjust screw
c. Foot
d. Finger
260. Scale Assembly-consists of:
a. Mounting screws (2 req'd)
b. Bumper pointer stop (2 req'd)
c. Scale
330. Diaphragm Assembly -consists of:
(Arbor press needed to install)
a. linkage assy., complete
b. Front plate
c. Diaphragm
d. Rear plate (not shown)
e. Plate washer (not shown)
360. Mounting Hardware Kit
a. Adapter -pipe plug 1/8" NPT to
rubber tubing - (2 req'd)
b. Pipe plug 1/8" NPT-(2 req'd)
c. Mounting lug (3 req'd)
d. Long screw (3 req'd)
e. Short screw (3 req'd)