Carl Goldberg GBGA1020 - Manual (Page 10)

10
Mounting Cowl
1. Collect the following parts:
(1) Fuselage
(1) Cowl
(3) #2 x 3/8 screws
2. Place masking tape .over each of the cowl
mounting blocks.
Make a mark in the middle of the mounting
block.
Draw a 1” long straight line back from the
block.
Make another mark at the 1.” length.
3. Repeat this for the remaining blocks.
1”
1”
4. Slide the cowl over the motor and onto the
fuselage.
Center the motor and tape the cowl in place.
Draw a 1” long straight line back down over
the cowl and make a mark.
Drill a 1/16” hole and screw in place.
3. Repeat this for the remaining blocks.
1. Using glass cleaner and a soft cloth, clean the
model surface thoroughly before applying
decal's.
Cut the decal sheets apart in sections, as
needed.
Peel the backing off the decal and apply the
decal to the location desired.
Decal Locations
Control Set Up
Turn on your transmitter and plug in the receiver battery. Center all the control surfaces (rudder, ele-
vator & aileron). If required by your speed control this is the time to program it for your use.
Control Travel
Aileron up / down 1/2”
Elevator up / down 3/4”
Rudder right / left 1”
You will want to adjust these throws to suit your flying abilities. The throws given are starting
throws.
Balancing
Balance the Laser 200 at 2-5/8 back from the leading edge of the wing next to
the fuselage.