Carl Goldberg GBGA1020 - Manual (Page 4)

4
Installing Ailerons
1. Collect the following parts:
(1) Wing
(2) Ailerons ( Left & Right)
(6) Mini CA hinges
2. Locate the pre-cut aileron hinge slots in both
sides of the wing. Using a hobby knife (#11
blade), slide the blade into each slot to make
sure it is cleanly cut.
Repeat this process with the ailerons, making
sure all hinge slots are clean.
3. Insert the mini CA hinges half way into the
wing and the ailerons. (Use a pin inserted into
the middle of the hinge to help keep the hinge
in the middle.)
Make sure that the aileron is tight against the
wing and even with the wing tip.
Using Ultra Set thin CA glue, place one drop
on all hinges top and bottom.
Repeat for the second wing half.
1. Gather the following items:
(2) 6" Extension wires
(2) Wing
(2) Servos
(1) Electrical tape
2. Plug one 6" extension wire into one servo.
IMPORTANT! To ensure that any connections located
inside the wing will not come loose, either when the
wires are pulled, or during flying, always tape them
securely together with electrical tape.
Installing Aileron Servos
Aileron Control Horns
1. Gather the following items:
(2) Small Control Horns
(2) Wing
(2) Short pushrods
(2) EZ Connectors With Hardware
(2) Swivel Keeper
2. Cut the back plate off the side of the control
horn.
3. Locate the pre-drilled control horn holes in the
aileron.
Place glue on the control horn pins and insert
them in the holes.
Install the back plate on the control horn pins
on top of the aileron. Use glue to hold in place.
3. Insert the servo wire plug into the servo hole
in the bottom of the wing.
thread the servo wire through the wing and
out the center hole in the wing tube.
Mount the servo to the wing.
4. Repeat for the other wing half.