Carl Goldberg GBGA1020 - Manual (Page 7)

7
3. Place the wheel in the wire and insert the tub-
ing on the end of the wire.
Fin & Rudder Installation
1. Collect the following parts:
(1) Fuselage With Stabilizer
(2) Fin & Rudder
(2) Mini CA Hinges
(1) Nylon Control Horn
(1) Long Pushrod Wire
(1) Tail Wheel Wire
2. Find the tail wheel wire, wheel and the small
plastic tubing keeper.
Insert the tail wheel wire into the bottom of the
rudder.
Glue in place.
4. Slide the fin into the slot on the top of the fuse-
lage.
Mark the location of the fuselage on the fin.
Being very careful, remove the covering off
the fin where the wood is only.
5. Glue the fin into the fuselage using Ultra Set
epoxy.
6.. Place 3 hinges in the rudder half way.
Mount the rudder to the fin.
2. .Remove the back plate off the control horns.
1. Collect the following parts:
(2) Nylon Control Horn
(2) 20” Long Pushrod Wire
Pushrod Installation