Carl Goldberg GBGA1020 - Manual (Page 8)

8
Wheel Pants
1. Collect the following parts:
(2) Wheel Pants
(4) Wheel Collars with set screws
(2) 2mm x 3mm Sheet Metal Screw
(2) Wheels
Landing gear Wheel Pant
Wheel
Wheel Collar
2mm x 3mm Sheet
Metal Screw
3. With the fuselage upside down place a drop of
glue on the control horn and insert the eleva-
tor control horn in the left side elevator holes.
Insert the back plate onto the control horn pins
sticking out the top of the elevator.
Place a drop of glue on the pins to hold the
back plate in place.
4. Insert the pushrod into the tube in the fuse-
lage.
Make a 1/4” bend at the end of the pushrod
and place it in the control horn.
Place a swivel keeper on the end of the
pushrod.
5. Repeat steps 2 through 4 for the rudder
pushrod and control horn.
Cut-A-Way of wheel pants shown right
side up
Wheel Collar
2. Install the wheel pants as shown above.
3. Install the tail wheel.