Carl Goldberg GBGA1020 - Manual (Page 3)

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 4 CHANNEL RADIO WITH 4 MICRO SER-
VOS. (WE USED 4 CHANNEL FUTABA
RADIO WITH S3110 SERVOS AND
FUTABA RECEIVER )
1 6” SERVO “Y” HARNESS
2 6” SERVO EXTENSIONS
1 ELECTRONIC SPEED CONTROL
1 (1500mah three cell Li-Po battery).
1 BRUSHLESS MOTOR (We used a Rimfire
35-30-950 and a AXI 22I7-16 motor)
1 PROP ADAPTER
1 ELECTRIC PROPELLER (We used an 11-
4.7 prop)
1 ULTRA SET CA ACCELERATOR
1 ULTRA SET 1 OZ. BOTTLE CA MEDIUM
GLUE
1 ULTRA SET 1/2 OZ. BOTTLE CA THIN
GLUE
1 ULTRA SET 5 MINUET EPOXY
1 1/4” FOAM RUBBER
1 SHEET METAL SCREWS FOR
MOTOR(MIGHT BE REQUIRED FOR SOME
MOTOR INSTALLATIONS)
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X48")
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
24” RULER
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
5 FT. LENGTH OF STRING
Caution:
Before starting, carefully go
over all high stress areas
(Wing bolt mounting blocks,
Firewall,etc.) with an epoxy or
wood glue to confirm all
areas are well glued.
Warnings about Lithium
Polymer batteries
NEVER charge Lithium Polymer batteries with a
charger designed for NiCd, NiMH, or any
other type of battery chemistry. Use ONLY
the chargers listed under REQUIRES or
equivalent substitutes.
Do not allow Li-Po cells to overheat at any time. Cells
which reach greater than 140° Fahrenheit
(60C) will usually become damaged and
could catch fire.
Do not charge or discharge Li-Po cells on or near
combustible materials including paper, plastic,
carpets, vinyl, leather, wood, inside an R/C
model or full size automobile.
Do not expose Li-Po cells to water or moisture at any
time.
Do not store batteries near an open flame or heater.
Do not assemble Li-Po cells or pre-assembled packs
together with other Li-Po cells or packs.
Do not allow a Li-Po battery to be left unattended dur-
ing charging or discharging.
Always store Li-Po batteries in a secure location
away from children.
Always remove a Li-Po battery if model is involved in
any kind of crash. Carefully inspect the
battery and connectors for even the
smallest damage.
CAUTION, cells may be hot!
Do not allow the electrolyte to get into eyes or on
skin. Wash affected areas immediately if
they come into contact with electrolyte.