Lighting standing piiots, To light range pilots, To light oven burner pilot – Whirlpool FGP315B User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
U S I N G Y O U R R A N G E
Lighting standing piiots
(model« FGP210V, FGP300B and FGP310B)
To light range pilots:
1. Make sura all controls are turned off.
2. Remove the surface burner grates from
the cooktop. Remove the cooktop. (See
"Removing the cooktop” on page 18.)
3. To light, hold a lit match over the pilot
light located between the front and back
burners. The pilot flame should be V4to
V
b
in (.6-1 cm) high.
Pilot light
4. If the pilot flame needs adjustment,
turn the pilot adjustment screw behind
the Oven Temperature Control, under the
control panel.
5. Replace the cooktop and the grates
before using the surface burners.
To light oven burner pilot:
1. Maks sure the Oven Temperature
Control is turned off.
2. Pull broiler drawer open. Broiler door will
tut down when opened.
3. Remove broiler pan, grid, and broiler
carriage. (See "Removing the broiler
carriage” on page 21.)
4. Hold a lit match over the oven burner
pilot located at the rear of the burner.
5. After the oven burner pilot is burning
steadily, check burner lighting by turning
the Oven Temperature Control to a
temperature above 140°F (60"C). The
burner will take 50-60 secorKis to light.
6. Replace the burner carriage, broiler pan,
arxJ grid.
7. Close broiler drawer all the way.
Broiler carriage
11