Whirlpool FGP315B - Manual (Page 25)

I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM POSSIBLE CAUSE SOLUTION
Bunwr
flames are
uneven
Burner ports are clogged. Clean with a straight pin (see pages
19 and 23). If this fails, call an
authorized Roper service technician
for service.
Burner
flames lift off
ports, are
yellow, or
are noisy
vrhen turned
off
Air/gas mixture is incorrect. Contact an authorized Roper service
technician to check air/gas mixture.
Burner makes
popping noise
when on
Burrrer is wet from washing. Let dry.
Control
knob(s)will
not turn
You are rrot pushing in before
turning. Push control knob(s) in before
turning to a setting.
Cooking
results are
The range is not level. Level range. (See Installation
Instructions.)
not what you
expected
The oven temperature seems
too low or too high. Adjust the oven temperature control.
(See “Adjusting the oven temperature
corrtroT on page 13.)
The oven was rrot preheated as
the recipe calls for. Preheat oven if called for in recipe.
The recipe has never been
tested or is not from a reliable Use only tested recipes from a
reliable source.
source.
The parts are rtot the type or
size recommended in the Refer to a reliable cookbook for
recommerxled pan type and size.
recipe.
There is not proper air circula-
tbn around pan when baking. Allow 1to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Rame size does rtot fit the
cooking utensil being used.
Adjust flame size to fit cooking
utensil.
When broiling, you have not
completely closed the broiler
drawer. Completely close broiler drawer.
25