Whirlpool Thin Twin - Manual (Page 18)

5. Remove the top two (2) retaining screws.
6. Remove the bottom two (2) screws.
7. Remove the Lint Screen.
8. Remove the three (3) Dryer Lint Duct assembly
retaining screws and remove the assembly.
(Fig. 24)
9. Remove the four (4) heater element shield screws.
(Fig. 24)
10. The Dryer Front Panel can now be removed.
Screw
Screw
Lint Duct Heater
Assembly Element
Fig. 24
Shield
Dryer Drive Motor Access
1. Remove the Toe Panel.
2. Remove the Dryer Lint Screen.
3. Remove the Dryer Lint Duct Assembly.
4. Remove the Blower Assembly, Transition Duct
and Blower Plate by removing the retaining
screws.
(Fig. 25)
5. Using a ratchet and extension to hold the drive
motor shaft stationary, remove the Blower
Wheel.
Retaining
Screws
Fig. 25
NOTE: The Blower is reverse threaded and is removed by turning it clockwise.
11