Whirlpool Thin Twin User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Wet the inside of the drain hose with water. DO NOT USE ANY OTHER LUBRICANT.
5. Squeeze the ears of the drain hose clamp with a pair of pliers and place the clamp over the end
of the drain hose.
(Fig. 2
-
Inset A)
6. While holding the clamp open, work the end of the drain hose onto the drain connector.
7. Position the clamp over the drain hose area marked “clamp.” Release the clamp. Clamp
should be 14” from the end of the hose.
(Fig. 2
-
Inset B)
Cold Water
Inlet Valve
Connector
Hot Water
Inlet Valve
Connector
Flat
Washers
Both Ends
Shipping Strap
8. Open the yellow clamp by squeezing the ears together and slide it over the "hook” end of the
drain hose to secure the rigid and corrugated sections together.
(Fig. 3)
Fig.3