Using two vcrs for copying and editing tapes, Recording – GE VG4275 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
Using Two VCRs For Copying and
Editing Tapes
Use one VCR as the
playback VCR
and the other as the
recording VCR.
1. Connect the VCRs using the diagram at the right.
2. Turn on both VCRs and the connected TV.
3. Tune the TV to the VCR viewing channel (either 3, 4, or
video line input - see "How to Find Your TV's Video
Input Channel" in the References section of this
manual for more information).
4. If using coaxial cables for the connection, tune the
recording VCR to
channel 3 or 4—the one used by the
playback VCR.
If using audio/video cables, select the line input on the
recording VCR
(LI for the jacks on the back of the VCR
or L2 for the jacks on the front of the VCR).
5. Insert the tape to be copied into the
playback VCR.
Insert a blank tape with its safety tab in place into the
recording VCR.
6. Using visual search, locate the segment to be copied
on the
playback VCR.
Pause the tape at this location.
7. Press RECORD on the
recording VCR,
then PAUSE.
8. Press PAUSE on both VCRs to begin copying.
9. Press PAUSE on both VCRs to stop copying.
10. Repeat steps 6-9 to copy or edit additional segments.
Connecting Two VCRs
TO TV
TO TV
The VCRs used in this diagram may not match the two
VCRs you use. Make sure to connect OUT to IN jacks and
vice-versa.
Also, make sure to match up the types of jacks (R jacks
are connected to R jacks, L to L, and VIDEO to VIDEO).
34