How to find your tv’s video input channel, Appendix: reference – GE VG4275 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
APPENDIX: REFERENCE
How to Find Your TV’s Video Input
Channel
You need to tune your TV to the Video Input Channel if you
are using the VCR's AUDIO/VIDEO OUT jacks to connect to
the TV's AUDIO/VIDEO INPUT jacks. You must select this
"channel" before you can see the VCR's menus, the cable
or antenna reception, and the content that's on a tape.
The video channel on TVs varies for different brands and
different models. Below are some steps to try:
•
If your TV brand is GE, RCA, or PROSCAN, press the
TV button on the remote control that came with the
VCR. Then press the INPUT button on the remote.
•
If you have another brand of TV, consult the section.
Program the Remote,
to see if the VCR's remote
control can be set to control your TV. If so, follow the
step above.
If those options do not work, try the following ideas. You
might access the Video Input Channel by:
•
pressing a button on the remote (see table below)
•
selecting the channel from the TV's menu system
(see table below)
•
tuning directly to the channel by selecting a specific
channel number (see table below)
•
going through all the channels in the channel list by
pressing the channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input
Channel Variations table that follows:
TV Button
Video Input Channel Variations
Button/Switch
Button on the
Channel
on the TV
TV Remote
Number
VIDEO
VID 1
00
SIGNAL
LINE
90
VID 1
VID
91
VID 2
VIDEO
92
S-VID
S-VID
93
S-VIDEO
INPUT
VID 1
S-VIDEO
VID 2
SOURCE
AUX
57