GE CS975SDSS - Manual (Page 44)

Installation Instructions
H 3-WIRE CONDUIT INSTALLATION
Loosen the 3 lower terminal screws from
the terminal block. Insert the center bare wire
(white/neutral) tip through the bottom center
terminal block opening. On certain models,
the wire will need to be inserted through
the ground strap opening and then into the
bottom center block opening. Insert the two side
bare wire tips into the lower Ie1^ and the lower
right terminal block openings. Tighten the screws
until the wire is firmly secure (approximately
20 inch-lbs.).
NOTE: ALUMINUM WIRING:
Aluminum building wire may be used but it
must be rated for the correct amperage and
voltage to make connection. Connect wires
according to this Step 5 or Step 7 depending
on number of wires.
Terminal
block
Wire tipS'
Brocket
Conduit
Wire used, location and enclosure of splices,
etc., must conform to good wiring practices
and local codes.
E Skip to Step 8 and proceed with the
installation.
H 4-WIRE CONDUIT INSTALLATION
E Loosen the three lower terminal screws from
the terminal block. Remove the ground screw
and ground plate and retain them.
Cut and
discard the ground strap. DO NOT DISCARD
ANY SCREWS.
E Insert the ground bare wire tip between the range
frame and the ground plate (removed earlier) and
secure it in place with the ground screw (removed
earlier). Insert the bare wire (white/neutral) tip
through the bottom center of the terminal block
opening. Insert the two side bare wire tips into
the lower lel^and the lower right terminal block
openings. Tighten the screws until the wire is firmly
secure (approximately 20 inch-lbs.).
Before ^11 ^ Ground strap
Terminal
block
Ground strop
Af^er
Terminal'
block
Wire tips
Ground
screw
Ground plate
(grounding
to range)
Brocket
Wire used, location and enclosure of splices,
etc., must conform to good wiring practices
and local codes.
E Proceed to Step 8.
44