4G Systems XSJack T3e - Manual (Page 11)

11
If you have a fax machine connected without telephone receiver and
without dedicated offhook/onhook button, a trick may help:
Insert some sheet of paper in your fax machine as if you would like to
send a fax. Enter the service code as an imaginary destination number
and press 'Start' (or similar). The machine will now go offhook and will
dial the entered service code. After you can hear the response tone
from the XSJackT3 (loudspeaker on fax machine must be enabled!),
press 'Cancel' (or similar). As this is an exhausting method, it is highly
recommended to get a separate telephone for entering service codes.
Telephone operation
Making telephone calls
Making phone calls with the XSJackT3 is as easy as if it was a fixed
line. Just lift the telephone receiver, wait for the dial tone, and enter
your desired destination number including the area code. There are
several different dial tones which may indicate special conditions (refer
to page 24).
Actual dialling will take place after a specific time from the last entered
digit. By default this delay is set to 4 seconds. You may change this
period by using code
D3. Furthermore you can skip this period and
immediately let the connection be established by entering # behind the
destination number (code
D2).
Emergency calls to '112' can always be made - even without SIM card
or without being logged onto a network.
Description Format Example
D1
Dialling a number NUMBER 04091827364
D2
Quick dialling NUMBER # 04091827364 #
D3
Change dial delay * 02 * SECONDS # * 02 * 5 #