4G Systems XSJack T3e User Manual
Page 9

9
Step 4: Connecting the power supply
Connect the power supply unit to the XSJackT3
and the other end into a mains socket.
Step 5: Entering the PIN of your SIM card
Your XSJackT3 will now start up and may require the PIN of your SIM
card to be entered, if this security feature is enabled on your card. The
necessity of entering the PIN will be indicated by the rightmost LED
flashing (refer to page 6). If so, lift the telephone receiver, wait for the
corresponding dial tone, press the # key, enter your PIN, and confirm
by pressing the # key again. Depending on if the entered PIN was cor-
rect or not, you will hear a positive or negative acknowledgment tone.
In the latter case, try to enter the PIN again. Check the LEDs and
signal tones since it may also be necessary to enter the PUK now
(refer to page 19). Refer to page 24 for an overview of all tones. The
PIN remains stored in the XSJackT3.
After you have entered the correct PIN code or if your SIM is not PIN-
secured at all, the device will automatically log onto the GSM network,
which may take up to 45 seconds. When the signal strength is shown
and a continued dial tone can be heard in the receiver, the XSJackT3
is ready for operation.
Note: To minimize interference, you should position the XSJackT3, the
antenna, your telephone, and all their cables as far apart as possible.
Ensure an adequate distance between the device and potential
sources of interference such as microwaves or electrical devices with
metal housings or metal objects in general.
,
, PIN,
,