4G Systems XSJack T3e - Manual (Page 17)

17
SMS operation
Short messages (SMS) can be sent and received via the GSM network
between a remote party and a connected telephone capable of doing
fixed line SMS. To use SMS functionality, the XSJackT3 has to be con-
figured once. You need to know the number of the service center for
SMS of your network provider (SMSC).
Configure the number of your SMSC in the connected terminal both as
the number for sending and the one for receiving SMS. You may want
to refer to the terminal's user manual for more information. The number
must be in international format beginning with the country code. After-
wards set the same number in the XSJackT3 using code
S1, which
also enables SMS functionality.
If you cannot change the SMSC number in your terminal, use code
S2
for configuration. The refered 'GSM-SMSC' is the one of your network
operator and the second 'Terminal-SMSC' is the fixed one of your ter-
minal.
Incoming and outgoing SMS are buffered on your SIM card. If there are
unsubmitted SMS on your SIM, the red status LED will flash. Retrieve
those SMS using code
S5. Remove all unread SMS with code M1. Be
aware that this will also delete all unread faxes if fax functionality is
used.
Description Format Example
S1
Set SMSC num-
ber(s) and enable
SMS functionality * 17 *
GSM/Terminal-SMSC # * 17 *
491701234567 #
S2
* 17 * GSM-SMSC *
Terminal-SMSC # * 17 *
491701234567 *
0193010 #
S3
Disable SMS # 17 #
S4
Query
GSM-SMSC
number * # 17 #
S5
Get waiting SMS
from SIM card * 12 # Codes also apply for
fax operation! Refer
to page 15!
M1
Clear SMS and /
or fax memory * 160016 #