Electrical, Warning – Genie Excelerator User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A

electrical

warning

To reduce the risk of electrical shock, this equipment has
a grounding type Plug that has a third (grounoing) Pin.
This Plug will only fit into a grounding type outlet. If the

Plug does not fit into the outlet, contact a qualified

electrician to install the proper outlet.

Do Not

change

the Plug in any way.The door Opener must be properly
grounded to prevent personal injury and damage to

the

components.

The electrical power to the door Opener

Must Be

removed

when the Motor Cover is removed. Electrical power must

remain off while making electrical connections.

A

Check building codes:

If building code requires Opener be permanently wired

to building, have a

licensed electrician

perform step B.

If you are not installing permanent wiring, go to step C.

B Instructions for licensed electrician - connecting power

with permanent wiring (Figure 33):

Remove power from circuit.

Remove Motor Cover.

Remove and discard Power Cord.

-

Cut off Power Cord inside Power Head as near Strain

Relief as possible.

-

Remove Knock-Out Plug, Strain Relief, and Power

Cord. (Cut Ground Wire on line side ofToroid).

-

Dispose of Plug, Strain Relief, and Power Cord.

Install required entrance bushing.

Connect permanent wiring to Power Head Wires.
-

White supply line to Opener White Wire.

-

Black supply line to Opener Black Wire.

-

Ground to Opener Green Wire.

-

Replace Motor Cover.

NOTE

Use only Underwriters Laboratories, Inc. (U.L.)
recognized wire nuts.

The Circuit Boards are light sensitive. Ensure the

Motor Cover is installed before energizing

the Opener.

- Restore Power to circuit.

Connecting Power with Plug:

Plug Opener into a grounded outlet as stated in previous
electrical warning.

Perform Safe-T-Beam® alignment check:

Check if Safe-T-Beam® Source Red LED is glowing
continuously (OK) or blinking (problem).

If Red LED is blinking twice, adjust Sensor Brackets as
needed to make Red LED glow continuously. (Refer to
page 26.)

Knockout

FcM' Help, call

1

-

800

-

3

S

4

SEiiE or ¥islt i«%wi.ferileccirnpiirif.corn

19

Advertising