Warning, Fcc and ic certified, Trarisiriitter cöinpliarice – Genie Excelerator User Manual

Page 25: Jtatemerit

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Snap Lens Hinges into

slots on back of Motor Cover

60 Watts

maximum

B

C

Figure 41

Install Lens Cover and Light Bulbs

Install two 50 Watt light bulbs (not included) into Light
Sockets

(Figure 41):

• Rough service, 130 Volt bulbs are recommended.

Install Lens into slots in Motor Cover.

Install Genie Emergency Release Kit

(GER-2)

accessory,

if purchased.

Installation is now complete.

Trarisiriitter Cöinpliarice

5

Jtatemerit

Transmitters comply with all United States and Canadian legal requirements
as of the date of manufacture. No warranty is made that they comply with all
legal requirements ofany other jurisdiction. If transmitters are to be used in
another country, the importer must determine compliance with any local
laws and regulations which may differ from United States and Canadian
requirements prior to use.

Los transmisores cumplen con todas las reglamentaciones legales de los
Estados Unidos y del Canadá, en la fecha de fabricación. Ninguna garantía
se da que cumplan con todas as reglamentaciones legales de ninguna otra

jurisdicción. Si los transmisores se van a utilizar en otro país, el importador

debe determinar si cumplen con las reglamentaciones y leyes locales que
puedan ser diferentes a las reglamentaciones de los Estados Unidos y del
Canadá, antes de usar los mismos.

Les émetteurs sont conformes à la réglementation américaine et canadienne
à compter de leur date de fabrication. Aucune garantie n'est stipulée
indiquant qu’ils sont conformes à toutes les prescriptions juridiques d'autres
autorités. Si les émetteurs sont utilisés dans d'autres pays, il incombe à
l'importateur d'en déterminer leur conformité aux lois et règles locales
pouvant différer de celles des États-Unis et du Canada avant toute
utilisation desdits émetteurs.

Sendegeräte entsprechen allen gesetzlichen Bestimmungen in den USA und
Kanada zum Zeitpunkt der Herstellung. Wir übernehmen keine
Gewährleistung für die Einhaltung aller gesetzlichen Bestimmungen in
anderen Ländern. Sollen Sendegeräte in anderen Ländern eingesetzt werden,
so muss der Importeur vor dem Gebrauch sicherstellen, dass die Sendegeräte
auch solchen lokalen Bestimmungen entsprechen, welche von den
Bestimmungen der USA und Kanadas abweichen,

«ihTtœ 01.

« T'ÄÄft

spsff a* »»

íe

I' 7 >X 5 -Vó'-H.

u

LfnSüft. |lISÍ,a0ttJl(C56ÍI®ffifi§Wíbnb0IMAr¿;#|7S?,f:

¿ s, 5 fc 0.

«1

A# H nnáf, átfi A B 0

W A 2ptM A A b ¿ S «

fgbítíttliíAUÍ-a'A,

E0j^D|Ejse DRuf nm aeioiiAi

« 5

w»» gzisiioj

s

^

aiikhi

ttjEjof SMcf 7|Ej c\E awasi Hë gsjoj s.^

a

UJO

ii

tcjEjof Sfe aiêJ

ë siôMEK eia MazsDiEjgoi 7|E| CB xigoiiAf Afsa ëSJSAfe

A®5|7|0||

o

>A1 nR3t 7imq.fijo| SëAfîfafe CUXlEaëë n A|«°|

gm 5BII0II n|E|0| IfA|°| 01^1 igsiiot îfMcK

A

Monthly:

• Door springs and door hardware:

- Oil door roller, bearings, and hinges using silicone

lubricant or light oil.

Push in

Latches

to

close

Lens

A

WARNING

Do not operate door automatically or manually if springs

are broken. Contact a Genie Factory Authorized Dealer for
service or call Customer Service at

1-800-35-GENIE.

• Balance Door.

- Close door.
-

Release Magnetic Carriage Assembly from Rail Assembly
by pulling down on Emergency Release Knob.

-

Raise door manually 3'- 4' and verify that door stays at

that position. See Check Step 2 on page 3.

NOTE

When the door is 3' - 4' above the ground, the door
should stay open. Slight movement is acceptable. If
the door moves too much, contact a Genie Factory
Authorized Dealer for service or call Customer Service at

1-800-35-GENIE.

- Reattach Magnetic Carriage Assembly to Rail Assembly:

a. Pull the Emergency Release Knob toward Power Head.

b.

Close door.

Contact Reverse Test.
-

Perform Installation Step 10 on page 21.

If the door fails to reverse on contact with the board,

adjust the Close Force Control as specified in Set Limit
Switches and Force Controls on page 20. If the Opener
still fails, contact a Genie Factory Authorized Dealer for
service or call Customer Service at

1-800-35-GENIE.

Yearly:

• Wipe off old excess lubricant from Drive Screw.
• Lubricate Drive Screw with Genie Lubricant (GLU-3)

NOTE

Use ONLY Genie Lubricant
may damage the Opener.

GLU-3).

Other lubricants

GLU-3

Lubricant

FCC AND IC CERTIFIED

All devices comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ­
ing interference that may cause undesired operation.

FcM' Help, call

1

-

800

-

35

-GEiîE or visit LVLWi.ferilsccirnpiirif.corn

25

Advertising