Genie Excelerator User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Check for wood garage frame, jamb, or masonry at mounting location
(6" above floor) with attachment tabs facing away from garage door

(Figure 7).

A

If you cannot mount Safe-T-Beam® Mounting Bracket to

wood frame:

Concrete screws and concrete anchors (not included)
must be used to mount Brackets on masonry with
attachment tabs facing away from garage door.

Safe-T-Beam® Mounting Bracket Extensions may be used

(not included - available from a Genie Factory Authorized
Dealer or through Accessories Order Form on pages 31/32).

* •

A

Tools

(Figure 8):

B

Additional tools to make installation easier:

Slotted and phillips screw-driver bits

Stud finder

Sheet-metal cutting snips

Check that the garage door locks, rope, and T-Handles are removed

from the garage door before starting the installation.

A

If your garage does not have a separate entry door, it is highly

recommended to install a Genie Emergency Release Kit

(GER-2).

Emergency Release Kit lets you open garage door from outside if

there is a power failure. (Please see Accessories Order Form on

pages 31/32.)

Safe-T-Beam® Sensor Mounting Bracket Extensions (dealer)

Garage door opener reinforcement bracket (dealer)

Garage door frame reinforcement brackets, screws, bracing
or reinforcement kits (dealer)

Lag Screws (11/4") for a wood door less than 2" thick (store)

Electrical outlet and/or wiring (supplied by a
licensed electrician)

Excelerator Extension Kit (for 8' garage doors) (store)

Sufficient angle iron or strapping for hanging Power Head
(store)

Two 60 Watt light bulbs

(Rough service bulbs recommended)(store)

GER-2 Emergency Release Kit for entry during power failure

(store)

Wood for header, ceiling, and/or door bracing reinforcement

(if needed)

Masonry fasteners for Safe-T-Beam® Bracket installation,
(if needed)

Masonry drill bit (if needed)

1

/

16

"

5

/

32

"

Drill Bit Drill Bit

12

' +

Tape Measure^

Phillips Screwdriver

Wire

Stripper

Carpenter's Level

Figure 8 Recommended Tools

FcM' Help, call

1

-S

00

-

3

S

4

SEiiE or visit %wi»i.ferilecornparif.ccirn

Advertising