9. at-300 automatic antenna tuner connection – Kenwood TS-850S User Manual
Page 80
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
7-8. AT-850 AUTOMATIC ANTENNA TUNER UNIT INSTALLATION
1. Remove the top cover of the transceiver. Refer to
Section 6-6-1.
2. Remove the shield cover of the filter unit.
5. Attach the cables from the AT-850 as shown.
3. Carefully remove the coaxial cable.
4. Attach the AT-850 and screw it on.
6. Replace the shield cover and the top cover.
Coaxial cable
7-9. AT-300 AUTOMATIC ANTENNA TUNER CONNECTION
When the AT-300 is connected to this unit, slide switch SW1 on the back to EXT. The built-in antenna tuner will
then not operate.
70
Advertising