8-9. tuning dial torque, 8-10. linear amplifier control, Note – Kenwood TS-440S User Manual
Page 28: Tuning dial torque
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5-8-9. TUNING dial torque
Turn the VFO knob while holding the silver ring. As the
VFO knob is turned clockwise, drag will be increased.
5-8-10. Linear amplifier control
As delivered from the factory, the external keying re
lay for control of a linear amplifier is disabled. If you
want to connect a linear amplifier connect the jumper
wire on the Switch unit to the ON terminal as shown
in the accompanying figure.
Note: ----------------------------------------------------------------------------
The control relay functions only when the jumper wire
on board X41 -1610-N/14 is connected to the ON po
sition.
Rear panel
26