Kenwood TS-440S - Manual (Page 30)

MODE Terminal connection
OPTIONAL CRYSTAL\^SELECTIVIT y \
FILTER COMBINATION ^\P0SITI0 n '
USB LSB C W FSK A M FM White lead Blue lead
AUTO 2.2 kHz 6 kHz
N
No sound from the speaker
No optional filter MI 12 kHz WIDE WIDE
M2 2.2 kHz
W 6 kHz
AUTO 2.1 kHz 6 kHz
N No sound from the speaker
YK-88S MI 2.1 kHz
6 kHz
12 kHz SSB SSB
M2 2.2 kHz
W 6 kHz
AUTO 1.8 kHz 6 kHz
N No sound from the speaker
YK-88SN MI 1.8 kHz
6 kHz
12 kHz SSB SSB
M2 2.2 kHz
W 6 kHz
AUTO 2.2 kHz 500 Hz 6 kHz
N 500 Hz
YK-88C MI No sound from the speaker 12 kHz CW WIDE
M2 2.2 kHz
W 6 kHz
AUTO
6 kHz
N
YK-88CN MI No sound from speaker 12 kHz CW WIDE
M2 2.2 kHz
W 6 kHz
AUTO 2.1 kHz 500 Hz 6 kHz
N 500 Hz
YK-88S and YK-88C MI 2.1 kHz 12 kHz CW SSB
M2 2.2 kHz
W 6 kHz
AUTO 2.1 kHz 270 Hz 6 kHz
N 270 Hz
YK-88S and YK-88CN MI 2.1 kHz 12 kHz CW SSB
M2 2.2 kHz
W 6 kHz
AUTO 1.8 kHz 500 Hz 6 kHz
N 500 Hz
YK-88SN and YK-88C MI 1.8 kHz 12 kHz CW SSB
M2 2.2 kHz
W 6 kHz
AUTO 1.8 kHz 270 Hz 6 kHz
N 270 Hz
YK-88SN and YK-88CN MI 1.8 kHz 12 kHz CW SSB
M2 2.2 kHz
W 6 kHz
AUTO 500 Hz 270 Hz 6 kHz
N 270 Hz
YK-88C and YK-88CN MI 500 Hz 12 kHz CW SSB
M2 2.2 kHz
W 6 kHz
6-2. VOICE SYNTHESIZER UNIT VS-1
INSTALLATION
1. Remove the top cover from the radio. 5.
2. Remove the two screws on the rear of the IF unt
and raise the unit to allow access to the PLL unit.
3. Install the VS-1 in the area at the left rear of the 6 .
PLL unit using the three screws provided with the
VS-1. 7.
4. Install the 3-pin plug on connector J01 and the 8 .
8 -pin plug on connector J02.
Select the desired language that you want with
switch S-1 on the VS-1. ENG for English, or JA for
Japanese.
Install the 4-pin plug on connector ( 3 ) 05 the IF
unit.
Reverse step 1 . — 2,
Turn on the power switch and press the VOICE
switch. The frequency will be announced. Adjust
VR-1 for the desired audio output level.
28