Optional accessories, 1. crystal filter installation, Note – Kenwood TS-440S User Manual
Page 29: Yk-88c cw filter, Yk-88cn cw narrow filter, Yk-88sn ssb narrow filter, Yk-88s ssb filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. OPTIONAL ACCESSORIES
The following accessories are available for more
sophisticated operation of your transceiver.
6-1. CRYSTAL FILTER INSTALLATION
1. Remove the top cover from the radio. Be careful
of the speaker lead, which may be unplugged.
2. Remove the seven screws securing the IF unit to
the chassis.
3.
Install the crystal filter in the appropriate location
on the IF unit. The SSB filter goes towards the
center and the CW filter towards the edge of the
board. Solder the filter in place, and cut off the ex
cess lead lengths.
Note; -----------------------------------------------------------------------
When soldering use a low wattage iron (40 watts
or less), and a high quality rosin core solder. Do not
use acid core solder as this will eventually cause
damage to the circuit board. Solder quickly, but en
sure that you have a good solder connection. If the
connection is dull, or looks crystalized you will have
to remove the solder and try again.
4.
When installing the optional crystal filter, move the
white or blue lead, or both to the appropriate ter
minal as shown in the chart on page 28.
5. Replace the IF unit and secure with the seven
screws removed in step
2
.
6
. Reattach the speaker lead, and replace the top
cover.
Note: -----------------------------------------------------------------------
Two terminals are provided for the WIDE and SSB
jumper. Either of the two terminals may be used.
■ YK-88C CW FILTER
Center frequency
Passband width
Attenuation bandwidth
Guaranteed attenuation
8,830.7 kHz
500 Hz
(- 6
dB)
1.5 kHz ( - 6 0 dB)
More than 80 dB
YK-88CN CW NARROW FILTER
Center frequency
Passband width
Attenuation bandwidth
Guaranteed attenuation
8,830.7 kHz
270 Hz
(- 6
dB)
1.1 kHz ( - 6 0 dB)
More than 80 dB
YK-88SN SSB NARROW FILTER
Center frequency
Passband width
Attenuation bandwidth
Guaranteed attenuation
■ YK-88S SSB FILTER
Center frequency
Passband width
Attenuation bandwidth
Guaranteed attenuation
8,830.0 kHz
1.8 kHz
( -6
dB)
3.3 kHz ( - 6 0 dB)
More than 80 dB
8,830.0 kHz
2.4 kHz
(- 6
dB)
4.2 kHz ( - 6 0 dB)
More than 80 dB
YK-
88
C
YK-
88
CN
YK-
88
SN
27