JVC DVB TU-HD500A - Manual (Page 21)

Getting Started
Step 6. Install Remote Control battery and TV Control Section
Code Setting.
Install Remote Control battery. The battery has polarity so when insert the batteries,
make sure t h e a n d t e r m i n a l s are oriented correctly.
Setting up the TV Control Section Code, Alter tinished the TV Control Section Code
setting, the universal key of the HD STB can control for your TV,
For TV Control Section Code setting, follow the following process.
1. Press and Hold TV POWER button,
2. Enter three digits TV Control Section Code.
3. Release the TV POWER button.
You can find the 3 digits code for your TV at the end of this User’s Guide,
Please refer to the TV Control Section code setting.
Step 7. Check up the On Screen Display.
For verify correct setting ot Display Mode, you should check up the OSD trom HDTV's
display screen.
Turn on the HD STB and HDTV,
Press Menu button on the remote control, you should check up the OSD fer verify A/V
connection. If you cannot find any OSD in yourTV display, please check up again the
Display Mode switch position and A/V connection.
Step 8. Automatic Channel Search and Channel Change.
Please processing the Automatic Channel Search and find possible channels.
Please make sure, you should wait until fully searched.
You can change channel usingCHA or CHT butfon in your remote control.
Or you can direct select the channel using channel number.
Please make sure, the channel change operation is based on CH LIST in the internal
memory. If you edit, delete and move the memorized channel, you cannot access the
channel using CHA or CHT button or direct number enter. At that time, please perform
the Automatic CH Tuning or Manual CH Search tor re Scan the channel.
It you setting up the favorite Channel using Program Preference and Favorite CH in
the menu system, you can also change the channel using PR ^, PR '4 button for
Favorite Channel selection.
16