Maintenance, Installing a new journal roll, Removing the recorded journal roll – Toshiba TEC MA-71 User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
El-01402
12. MAINTENANCE
Paper Cover
Fig. 1
Paper Inlet
Journal Winding Reel
INSTALLING A NEW JOURNAL
ROLL
1. Remove the Paper Cover. (Fig. 1)
2.
Fold the paper roll at the tip for 15 to
20cm so that the paper may easily be
inserted. Hold the paper roll in the
direction as shown in the figure. (Fig. 2)
3.
Place the paper roll in the paper holder.
Insert the paper end into the Paper Inlet
located on the rear side of the printer,
and
press
the
[FEED]
key
on
the
keyboard until the paper end comes out
of the outlet. Meanwhile, the Mode Lock
should be set to the “REG” position.
(Fig. 3)
4.
Wind up the paper end on the Journal
Winding Reel two or three times. (Fig.
4)
5.
Set the reel to the reel holder, and then
attach the Paper Cover. (Fig. 5)
REMOVING THE RECORDED
JOURNAL ROLL
1. Remove the Paper Cover. (Fig. 1)
2.
Remove the Journal Winding Reel from
the holder. Tear off the recorded portion
of the paper, and draw it out from the reel
in the direction as shown in the figure.
(Fig. 6)
Recorded
Fig. 6
-48
-