Removing the receipt paper, Installing the journal paper, Removing the journal paper – Toshiba MA-215-10 SERIES User Manual
Page 52
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 7
Fig. 8
Journal
Inlet
Fig. 9
REMOVING THE RECEIPT PAPER
1. Remove the Paper Cover.
2. Press the Free Lever down and pull
the old paper core upward to remove
the remaining paper end. (Fig.7)
INSTALLING THE JOURNAL PAPER
1. Turn the Mode Lock to the "REG"
position.
2. Remove the Paper Cover by pulling it
upward,
and
remove
the
JournaI
Winding Reel. (Fig.l)
3. Follow Steps 3 and 4 of INSTALLING
THE RECEIPT PAPER on the previous
page.
4. Place the paper roll
in the
inner-side roll holder of the two
holders. (Fig.8)
5. Insert the paper end into the Journal
Inlet,
feed
the
paper
in
while
pressing down the [JF] key. (Fig.9)
6. When the paper comes out for a enough
length,
open
the
folded
end.
(Fig.10)
7. Wind the paper end on the Journal
Winding Reel two or three times as
shown in Fig.11.
8. Set the Journal Winding Reel to the
Reel Holder. (Fig.12)
9. Attach the paper cover.
REMOVING THE JOURNAL PAPER
1. Remove the Paper Cover.
2. Press the [JF] key to wind up enough
portion of the journal paper, and
then tear off the paper, holding the
Journal Winding Reel.
3. The wound-up portion of the paper can
easily be removed from the Reel by
pulling it side way. (Fig.13)
4. If enough paper remains on the roll,
follow Steps 6 through 9 above; if
paper is running out, follow Steps 1
through 9 above.
Fig. 13
-48-