Toshiba MA-141 - Manual (Page 15)

The preset price will automatically be read and
entered.
To repeat the same PLU price, depress the |PLU|
key only, after the above operation.
As for quantity extension involving PLUs, refer to the "REGISTERING
PROCEDURE FOR SALES".
Each PLU is programmed with a 3-digit PLU Code, a 2-digit link
department code, and a maximum 6-digit preset price. Each PLU is
also programmed with the taxable/non-taxable status.
To modify the link department, to modify the status, to delete PLUs,
or to re-program the entire PLU table, the entire PLUs sales totals
must be reset beforehand. However, additional PLU programming and
preset price changes of individual PLUs may be carried out anytime
if the register is outside a saie. But please not that if a unit
price of any PLU is changed between sales (but not after resetting),
the accurate data of the PLU total may not be printed in the X and
Z reports due to the change.
11 Percent Chctrge Key
This key is used to add a percentage rate to a sale. If the pre­
programmed percentage rate is to be added, depress the |^+1 key
without a prior numeric entry. If a rate different from the pre­
programmed % rate is to be added, enter the desired rate on the
numeric keyboard and then depress the [%+] key. (The manual rate
will take priority.)
To operate, depress the |%+1 key either immeidately after a depart­
ment entry if only that item requires the percentage addition, or
after the [ST| key has been depressed if required on the total bill.
The percentage rate and the amount are printed and will be added
to the sales total.
The percentage rate may be within the range from 0.001 to 99.999%.
The fraction resulted from the percentage calculation is usually
programmed to be rounded off. However, it can be programmed to be
rounded up or discarded.
Usually, if the 1%+] key is depressed after a second |ST | key
depression within a sale, it adds the rate to the sale total of the
items entered between the first and the second |ST| key depressions.
However, it can be programmed to add the rate to the entire sale
by the system option.
|%-1 Percent Discount Key
This key operates in the same fashion as the |%+1 key except that
operation will subtract from instead of adding to a sale.
I
DOLL DISC
I
Dollar Discount Key
This key is used to subtract an amount from the sale total such as
a discount during a sale. This key cannot normally be used outside
a sale. An amount exceeding the sales total cannot normally be
entered. However, when the "Credit Balance" option has been selected,
this key can be used inside or outside the sale and over-subtraction
of the sale total is allowed.