Toshiba MA-141 - Manual (Page 53)

SETTING THE LISTING CAPACITY OF DEPARTMENT (Condition: after a Z reset)
Mode Lock: SET Key Operation:
2 dig. 2^dig.
121 I X 1-^1HALCILALC|-^1 DEPT] -»|HALC|LALC| ~>rAT/TL|
T-----\
(NOTE 1)(N0TE 2)
Repeat until all
-the required indiv.^
department L.C.'s
are set.
7 r
(NOTE 1)(N0TE2)
I-
for common L.C. for all
the departments.
NOTE 1: HALC.... High Amount Listing Capacity
Number of digits
Value of the top digit
ex.)
[314j indicates 3999
'-—A H -i nr —-------------------- ^ 4 dig. ---
-Value of the_
top digit
NOTE 2: LALC.... Low Amount Listing Capacity
ex.)
►Number of digits
►Value of the top digit
[2 I 2J indicates 29
I
-?. Hi -2- dig.
Value of the
top digit
The amount range allowed to be entered:
equal to or smaller than the HALC,
and larger than the LALC
NOTES: 1. If the individual listing capacity of a department has
been set, it prevails over the common listing capacity
of all the departments.
2. To reset an individual department listing capacity, enter
"0" before the |DEPT| key in the above operation. Then
the common listing capacity of all the departments, if
pre-programmed, will prevail.
SETTING TENDER LISTING CAPACITIES (Condition: after a Z reset)
Mode Lock: SET Key Operation:
2 digits
‘HALCI -- IAT/TLI (Cash Tender Listing Capacity)
ICHk~"fNDl (Check Tender Listing Capacity)
IChgl (Charge Tender Listing Capacity)
(Misc. Tender Listing Capacity)
Refer to the
HALC descrip­
tion above. MSC
TND