Toshiba MA-141 - Manual (Page 52)

2. For TAX 2 Table programming, follow the same procedure in the
1), 2), or 3) above, using the |TX2/M| instead of the [TXl/MI.
3. If both TAX 1 and TAX 2 tables are programmed, the TAX 1 must
be set first. The TAX 1 table entry will automatically reset
both the TAX 1 and TAX 2 tables that have been programmed.
4. No second depression of the | ST 1 key is allowed within one
tax table programming.
SETTING NON-TAXABLE LIMIT AMOUNT (for a certain area only)
(Condition: after a Z reset)
This rtiay be programmed only when one tax modifier key ( | TX/M1 ) is
installed. The tax levied when exceeding this limit amount will be
calculated by the TAX 1 table.
Mode Lock': SET Key Operation:
I 9
I
—» I X I —>1 Non-taxable Limit Amount |—>| AT/ t IT|
NOTES: 1. If this program has been set, the tax is calculated and added
to the sale total which exceeds the limit amount even when
the sale is entirely composed of non-taxable items.
2. To reset the limt amount once set, enter "0" in place of the
¡Non-taxable Limit Amount] in the above operation.
3, This tax calculation program will be disregarded when the sale
total turns out to be negative.
^ In case the limit amount "$3.25'* is set:
Case 1: Normal Department Entry; (Mode Lock: REG)
I
3261^ rnon-taxable DEPT| -> [AT/TL|
.... The entered ■amount $3.26 is greater than the
limit amount $3.25. It will therefore be taxed.
Case 2: Returned Merchandise Entry: (Mode Lock: REG)
I r TN mdse i 13261 -> 1non-taxable" dept ] ->j AT/TL1
The non-taxable total is negative. The tax
already levied will therefore not be returned.