Cisco 700 - Manual (Page 90)

Cisco 700 Series Router Installation Guide
Establishing a Terminal Connection
B-4
In addition, check for COM port conflicts. If you suspect a hardware conflict, select
Start>Help, and search for ports>Hardware Conflict Troubleshooter. From the
Hardware Conflict Troubleshooter help window, you can launch the Hardware Conflict
Troubleshooter.
TPAD Support
The serial port can be configured as a TPAD port. Communications with the router through
the serial port for configuration purposes are not possible when TPAD is enabled. You can
continue to enter configuration commands by using Telnet.
The following example sets the serial port as a TPAD port:
Host> set serialport tpad
To switch from TPAD mode to configuration mode, do one of the following:
•
From the terminal connected to the serial port, enter ^A three times, followed by a
Return to restore the prompt.
•
From a Telnet session, enter the set serial config command.
The current state of the serial port can be displayed by using the show configuration
command in a Telnet session.
For complete information on TPAD, see the Cisco 700 Series Command Reference.
Character Delay Settings>ASCII Setup 0
Append line feeds to incoming
line ends Settings>ASCII Setup Deselected
Force incoming data to 7-bit
ASCII Settings>ASCII Setup Deselected
Wrap lines that exceed
terminal width Settings>ASCII Setup Selected
Table B-1 Hyperterminal Default Settings (continued)
Setting Location Value