Cisco 700 - Manual (Page 58)

Country-Specific Dialing Instructions
Cisco 700 Series Router Installation Guide 4-10
Step 2 Dial the second call.
Step 3 When the second call is answered, perform a short on-hook to connect the
original caller.
Country-Specific Dialing Instructions
Integrated Network Service (INS) ISDN lines are used in Japan. NET3 lines are used
throughout Europe and parts of Asia. 1TR6 ISDN lines are used throughout Europe. This
section describes analog telephone dialing instructions specific to these countries.
Dialing with INS ISDN Lines for Japan
To make an analog telephone call over INS ISDN lines in Japan from a telephone connected
to Cisco 700 series routers, take the following steps:
Step 1 Enter each individual number (called a dialing digit) of the telephone number on
the telephone keypad.
You must enter each successive dialing digit within 6 seconds of entering the
previous digit. If you wait longer than 6 seconds, an incomplete set of dialing
digits is sent to the switch.
Step 2 Send the entire set of dialing digits to the switch in one of the following ways:
•
Press the pound (#) key on the telephone keypad.
•
Wait 6 seconds without entering any more dialing digits on the telephone
keypad. After 6 seconds, the set of dialing digits is automatically sent to the
switch.