Chrysler 2015 300 - Owner Manual - Manual (Page 227)

When the ParkSense® switch is pressed to disable the
system, the instrument cluster will display the
“PARKSENSE OFF” message for approximately five sec-
onds. Refer to “Driver Information Display (DID)” for
further information. When the gear selector is moved to
REVERSE and the system is disabled, the DID will
display the “PARKSENSE OFF” message for as long as
the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when ParkSense®
is disabled or requires service. The ParkSense® switch LED
will be OFF when the system is enabled. If the ParkSense®
switch is pressed, and requires service, the ParkSense®
switch LED will blink momentarily, and then the LED will
be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORSЉ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORSЉ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIREDЉ message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Driver Information Display (DID) will display a
Љ
PARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ,
Љ PARKSENSE UNAVAILABLE WIPE FRONT SENSORSЉ
or ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 225