Using the panic alarm, Programming additional transmitters, Transmitter battery replacement – Chrysler 2015 300 - Owner Manual User Manual

Page 26

Advertising
background image

Using The Panic Alarm

To turn the Panic Alarm feature on or off, push and hold

the PANIC button on the RKE transmitter for at least one

second and release. When the Panic Alarm is activated,

the turn signals will flash, the horn will pulse on and off,

and the interior lights will turn on.
The Panic Alarm will stay on for three minutes unless

you turn it off by either pushing the PANIC button a

second time or drive the vehicle at a speed of 15 MPH

(24 km/h) or greater.
NOTE:

• The interior lights will turn off if you place the ignition

in the ACC or ON/RUN position while the Panic

Alarm is activated. However, the exterior lights and

horn will remain on.

• You may need to be less than 35 ft (11 m) from the

vehicle when using the RKE transmitter to turn off the

Panic Alarm due to the radio frequency noises emitted

by the system.

Programming Additional Transmitters

Programming Key Fobs or RKE transmitters may be

performed at an authorized dealer.

Transmitter Battery Replacement

The recommended replacement battery is one CR2032

battery.
NOTE:

• Perchlorate Material — special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate

• Do not touch the battery terminals that are on the back

housing or the printed circuit board.

24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Advertising