Defibtech DDU-2450 Series User Manual - Manual (Page 16)

AED status OK
Battery status
Expires 01/2018
Pads status Adult
Expires 06/2018
AED S/N 099999999
Battery S/N 099999999
Software version V2.2
To check the status of the AED
when the unit is off, press the
center softkey button. The display
screen will show unit status, battery
pack status, and pad status. After
a short period of time, the display
screen, and the unit will turn off.
AED Status screen
3.6 Completing The Installation
Once you have completed the previous steps to set up your DDU-2000 Series AED, follow this procedure:
1. Turn the unit on by pressing the ON/OFF button.
2. Listen for the “Call for Help” voice prompt.
3. Turn the unit off by pressing and holding the ON/OFF button.
4. Listen for the “Powering Off ” voice prompt.
5. Check Active Status Indicator (ASI) to verify that it is flashing green.
(Refer to the ” Self-Tests ” section in Chapter 7 of this manual for instructions on how to run a manually initiated self-test.)
3.7 Storing The DDU-2000 Series AED
Store the DDU-2000 Series AED, with defibrillation pads attached, in environmental conditions within range of the
specifications. (Refer to the “
Environmental ” section in Chapter 11 of this manual.) The unit should also be stored
so that the Active Status Indicator (ASI) can be readily seen.
The Active Status Indicator (ASI) should periodically flash with a green light. If it flashes with a red light or does not
flash at all, the DDU-2000 Series AED needs servicing. (Refer to the “
Checking The DDU-2000 Series AED Status ”
section in this chapter for more information.)
Defibtech recommends storing your AED in an easily accessible location.
.
Checking The DDU-2000 Series AED Status (continued)
3.
S
et
ting Up
The
DDU-20
0
0
S
eries AED
16
DAC-E2510EN-BB