Fleet Engineers INS-01017 - Manual (Page 2)

6. Slide the mount supports on the mounting tubes so they
line up with the support strap that fits between ribs 4 & 5
counting in from the outside edge of the fender (approx.
4-7/8” in from the outside
edge of the fender)
Now tighten the
mount support
set screw to
48 in. lbs.
+/_ 3in. lbs.
or 4 ft. lbs.
CAUTION: Do
not over tighten.
NOTE: the channels
between ribs 4 & 5 is
larger than the other
spaces.
3/8-16 S.S. Set Screw
3/8-16 S.S. Bolt
Mounting
Tube
Mount Support
Spray Mate
Fender
Approx. 4-7/8"
3/8 S.S. Flat Washer
Support Strap
3/8 S.S. Flat Washer
3/8-16 S.S. Lock Nut
Spray Mate ® Optional Accessories
Curved
Brush
Packaged
Set
part #031-01536
Mount
Packaged Sets
Conspicuity End Mount Plate
Packaged Set
part #031-01583
Support
Packaged
Set
part #031-00823
Connector
Packaged Set
part #031-00828
Flap
Reinforcing
Strap
part #033-04139
part #031-00883
part #031-00870
part #031-01250
031-01251
Installation Sheet # INS-01017 • Rev. F 3/13
7. Spot the mounting
bolt holes through
the mount
supports. Now drill
13/32 in. dia. holes
through the fender.
Please Note:
Flap weights are not recommended
and may void the warranty.
Painting Spray Mate ® fenders IS
NOT recommended and may void
the warranty. If painting is desired, a
Flex Agent MUST be added to the
paint!
8. Fasten the mount support, fender and support strap
together with the supplied hardware.